The IEC 62310 series of three standards applies to stand-alone operating a.c. static transfer systems (STS) intended to ensure the continuity of load supply through controlled transfer, with or without interruption of power, from two or several independent a.c. sources. This series of standards includes information for the overall integration of the STS and its accessories into the a.c. power network and includes requirements for the switching elements, their control and protective elements, where applicable. Part 1 of the series concerns general and safety requirements Part 2 of the series concerns electromagnetic compatibility (EMC) requirements Part 3 of the series (IEC 62310-3 herein) concerns methods of specifying performance and test requirements including applicable safety tests referenced in standard IEC 62310-1 for General and Safety requirements. This standard shall be applied for single-phase, phase-phase or three-phase static transfers in a. c. systems up to 1000 V. It takes precedence over all aspects of generic performance standards, and no additional performance testing is necessary. The requirements have been selected so as to be consistent with compatibility levels for lowfrequency conducted disturbances and signalling in public low-voltage power supply systems (see IEC 61000-2-2) as well as to ensure an adequate level of performance when the STS is applied in diverse critical load situations. The requirements take into account the differing test conditions necessary to encompass the range of physical sizes and power ratings of STS. A STS, whether presented as a unit or an assembly of units shall meet the relevant requirements of this part 3 of IEC 62310 as a stand-alone product. This standard does not apply to: - devices for d.c. source switching; - single source systems; - transfer systems using only electromechanical switching devices intended to be used in emergency power systems with interruption of the supply to the load during transfer. Such equipment is covered by IEC 60947-6-1 "Low-voltage switchgear and controlgear - Part 6: Multiple function equipment - Section 1: Automatic transfer switching equipment"; - automatic switching devices integrated into UPS covered by IEC 62040 series. NOTE Additional or different requirements may apply to STS intended for use on board of vehicles including ships and aircrafts, in emergency power systems subject to a particular regulation e.g. health care facilities, fire fighting or emergency rescue, in tropical countries or where elevations are greater than 1 000 m.